NX Sheet Metal

Welcome to the third edition of the Ally PLM NX Lunch Bytes Series. Our topic we cover in this edition is a Sheet Metal tutorial in NX 8.

Labels: , ,

1 Response to "NX Sheet Metal"

  1. Anonymous says:

    A couple of points:
    1. During Flange creation you use offset to position a flange. This gives a non-associative result. Use Match Face for a more robust design.
    2. Near the end of your presentation during Louver creation, you could demonstrate the ability to 'Make Sketch External' rather than suggesting the user re-create the sketch first.

Leave A Comment:

Powered by Blogger.